Control board and temp sensor

[Davef]

I just put a new control board in, and temp sensor. Fire pot fills appropriately and fire stick starts the fire. Auger keeps filling (overfilling). Then pellets overwhelm the fire and it goes out as fire stick cycles off?

Any suggestions of what I should look for to correct my problem?

TIA

 

[Cowboy1955]

Welcome from Texas to the group!
Have you checked the connections?

 

[Sparky]

Welcome to the club

 

[brewersfan73]

Welcome from Texas to the group!
Have you checked the connections?

This

Does the auger ever shut off? Or does it continuously run? If so, it sounds like your auger and fan connections might be swapped.

Does your fan come on and stay on? The fire could get snuffed out because there isn't enough oxygen.

Just a couple of ideas.

 

[Davef]

I will check the connections again. Thanks for the suggestion.
Davef

 

[Davef]

You were right on. I had the auger and fan reversed. Switched them and it’s all good. Thanks for the direction..

Davef

 

[brewersfan73]

You were right on. I had the auger and fan reversed. Switched them and it’s all good. Thanks for the direction..

Davef

You are very welcome.

By the way, welcome to the group.

 

[Davef]

Thank you for the welcome. I always need help. This will be a great resource.

Davef

 

[Mike From R.I.]

welcome

 

[Jimsmokes]

Welcome from SC