During PB 3 Series Vertical Pellet Smoker assembly this "mystery screw" fell to the ground

[djsams]

Hi Everyone. During assembly of my new PB 3 Series Vertical Pellet Smoker this screw fell to the ground when I flipped the unit upright. It wasn't one of the packaged hardware included with assembly. I examined the entire unit from top to bottom looking for an obvious empty hole where this could have been but couldn't find a place for it. I guess it's possible that it was a random loose screw from the factory but thought I would run it past you experts to see if anyone recognizes it and knows if it should have a home in my new smoker. (Incidentally, the remainder of assembly and burn off process went fine with no issues.) Thanks! Dan

 

[Cowboy1955]

Welcome from Texas to the group!
If you didn’t see one missing it’s an extra but I’d hold onto it just in case down the road you lose one and need it
Hopefully this helps you

 

[Sparky]

Welcome to the group

 

[mixed up]

most of the screw are all alike on these units