Pitboss 820 Control Board Ground Wiring

[Jester236]

Hello,

I need to replace the control board on my 820. I realized after taking the board out I did not have a picture of where the green ground went. The only one in the wiring diagram appears to be the one tied into the main power that is still grounded. The board I'm replacing is itself a replacement of the original, is it possible this ground is no longer used? Thanks!

 

[Mike From R.I.]

I would call customer support; grounds are to protect the user.

 

[Jimsmokes]

Any floating/body ground will be fine.

 

[Jester236]

It's already grounded to the hopper, trying to figure out where the other end went.

 

[Jimsmokes]

Any ground goes to frame

 

[Jester236]

Sorry, maybe I'm not following. I'm referencing the green wire in the first picture. It is already attached to the frame. It appears as if the other end possibly went to the control board, though I couldn't find an obvious place where it would have attached.